Chicago Pneumatic 2204155653 Replacement Belt for QRS10 at 125-150psi Manufactured After Oct 2017 Reliable Quality

Chicago Pneumatic Replacement Belt Set for QRS 10 at 125/150psi Manufactured After October 2017 – 2204155653

Chicago Pneumatic recommends replacing the compressor belt every two years or 8,000 hours of compressor runtime, whichever occurs first. Belt tension and wear should also be checked every 500 run hours. This belt is specifically designed for the 125 and 150psi psi version of the QRS10HP and QRS10HPD rotary screw air compressors.

The 2204155653 XPZ belt set may also be displayed as or 2204 1556 53 in your parts manual. This OEM belt set and comes with two belts. These belts were also commonly used on several Atlas Copco rotary screw air compressors along with Quincy, BelAir and NAPA compressors. Please contact us if you would like to confirm this is the correct belt for you air compressor.

Changing the belt on your QRS 10 compressor by Chicago Pneumatic is fairly simple. The tension value is listed on the side of the belt housing. The belt is secured in place by two bolts on top of the belt housing. Simple loosing these to release tension. Remove the old belt, install the new, and then re-tension.

Please note these belts will only work with the QRS10 rotary screw compressors manufactured after 10/2017. There are several different belt sets available on these compressors depending on horse power, date of manufacture and pressure varient. Please contact us with your air compressor serial number for confirmation this belt will work with your air compressor.

This belt set will work for the following Chicago Pneumatic rotary screw air compressors:

• QRS 10 – 100PSI, 125PSI, 150PSI, 175PSI – 60Hz
• CPM 10 – 8BAR, 10BAR, 13BAR – 60Hz