Pressure Switch for Ingersoll Rand SS3R2-GM and P1.5IU-A9 Compressors Ingersoll-Rand Cheaper

Pressure Switch for Ingersoll Rand SS3R2-GM/P1.5IU-A9 Air Compressors – 54441738

54441738 is an OEM pressure switch manufactured by Ingersoll Rand. This is a common pressure switch used on their portable single stage reciprocating compressors. The pre-set cut-in pressure is 90 psi and the cut-off pressure is 125psi providing a 30 psi pressure differential. This was most commonly used on the SS3R2-GM and P1.5IU-A9 models.

This IR pressure switch utilizes 4 threaded ports on the bottom to attach the safety valve and pressure gauge. The unloader valve is swivel based and can be adjusted to fit the unloader tube if needed. An on/off switch is included with this item.

The pressure switch will often need to be replaced if the compressor does not turn on at the lower setpoint or does not turn off at the upper pressure setpoint causing the safety valve on the tank to pop. This results from the contacts being welded together over time. If you find your pressure switch is constantly leaking out of the unloader line, you should consider changing the check valve instead. Please call or email our parts department if you need help sourcing a check valve.

Plenty of aftermarket switches are sold online, but many of them are not rated for the full load amp draw of the compressor and will cause pre-mature wear to the switch. The OEM switch from Ingersoll Rand is rated for a higher amp draw and is much heavier duty compared to others.

This pressure switch will work on the following piston compressors from Ingersoll Rand:

• 2340S9GH-AS
• BA2
• SS3F2-GM
• SS3J2-WB
• SS3J3-AS
• SS3R2-GM
• P1.5IU-A9